We are trying to get our OneCNC software up and running on HAAS ST10-Y. But it’s not going so well. I have been in contact with the Florida office, but there have been some problems with that.

The posts we have do not give the correct M-codes for the live tooling, its giving Sxxxx rather than M133 Pxxxx. It is also calling up G12.1 and G13.1 commands, I believe these should be G112 and G113.

I also noticed that when we program in polar mode in the mill tools, it will use the G12.1 and also tries to use C axis commands. Should this not be X Y coordinates in a G12.1 (or G112) mode? The HAAS will convert the XY to XC in G112. Or am I completely miss understanding this? I am not an expert by any means.

I would also like to use the HAAS caned cycles for tapping in both radial and axial (face). G195 and G95

Any help you can offer would be greatly appreciated.

Thank you