We have set up the path, set all the parameters etc, but for some reason, it is asking for a diameter for the tool. We are using a 2mm square tool for the cutting, but it assumes the tool is round, thus leaves a 1mm gap around everything.
How do we change the tool to be a simple 2mm square tool?
Results 1 to 2 of 2
-
05-10-2014, 04:09 PM #1
Registered
- Join Date
- May 2014
- Posts
- 7
CamBam - Square Cutting Tool for lathe?
-
05-12-2014, 09:10 AM #2
Registered
- Join Date
- May 2014
- Posts
- 7
Re: CamBam - Square Cutting Tool for lathe?
Bump?
It seems like the software assumes that there is an overhead round cutting tool, and doesn't seem to take into account cutting from the side using a flat square tool.
Reply With QuoteSimilar Threads
-
Antique Champion Tool Works Lathe thread cutting.
By Hoader in forum Uncategorised MetalWorking MachinesReplies: 0Last Post: 04-24-2014, 04:20 AM -
How do I use these lathe cutting tools? (What cutting tool is for what operation?)
By Mike1000 in forum Uncategorised MetalWorking MachinesReplies: 9Last Post: 01-01-2013, 08:56 AM -
cambam lathe tool
By Papakel in forum CamBamReplies: 3Last Post: 07-23-2012, 03:03 PM -
help with cambam cutting parts in half
By ozon in forum Community Club HouseReplies: 0Last Post: 04-02-2012, 04:46 AM -
Cutting tool Phoenix-Paxton model WL36 CNC lathe
By garfieldsimons in forum Want To Buy...Need help!Replies: 0Last Post: 09-07-2010, 02:29 PM
Tags for this Thread
Posting Permissions
