603,349 active members*
4,908 visitors online*
Register for free
Login

Thread: tidy tool magazine

Results 1 to 2 of 2
  1. 09-20-2011, 10:32 PM #1
    kesh
    kesh is offline
    Join Date
    Nov 2010
    Posts
    680
    Hello

    Is there an M command to tidy the tool magazine? So that T1 is on Place 1 and so on?
    It gets a bit confusing after a while.

    With Fanuc it did not really matter because one was able to switch the tool over the spindle into the changer. However when I try that with the Maho, then I can’t deal with it.

    Regards
    Reply With Quote Reply With Quote
  2. 09-21-2011, 07:51 AM #2
    Weisl
    Weisl is offline
    Join Date
    Jul 2011
    Posts
    9
    Hello kesh
    It’s been a long time since I last worked on a Maho with Philips 432 but at that time there wasn’t such a M command. What controller are you working on?

    Regards
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules