[manfred50]

Dear Sirs,
hello from Austria. As a totally nuts in cnc matters I kindly ask for help, please.
My current issue is:
I got a new computer to run my cnc router. Therefore I have installed and setted up the Mach3 program.
I work pretty well, but it stops at line 500, as it is now recognized only as a demo-version.
I found the mach1lic.dat file on my installation disc.
I copied and pasted that file to my newly installed Mach3 program, but still it is not recognized as a full license version.
Anyone can tell me what do I wrong? Please.
Many thanks for your time and help,
greetings from Austria,
Manfred

[ger21]

Did the old license have your name in it, or someone else's?
If it's a pirated license, it won't work in newer versions of Mach3.

[manfred50]

Did the old license have your name in it, or someone else's?
If it's a pirated license, it won't work in newer versions of Mach3.

Hi,
many thanks for your attention.
Yes, the Mach3 progam had my name and license no. on it and I could see both under "Help" - pulldown menue.
Now, after installing that program to my new computer it only shows DEMO mode and license no. under the same section.
I am so desperate.

Thanks for any hint,
Manfred

[ger21]

Make sure you copy the file into the \Mach3\ main folder.
If that doesn't work, contact [email protected]

[manfred50]

Many thanks to ger21, following your instruction I could solve that problem.
Grateful greetings from Austria,
Manfred