[jouguet]

I have a milling cutter controlled by a Wantai TB 2520 Breakout board. It works well for my work.
I move to a new office last month and I can´t find the parallel cable DB25.
I asked the pin connection to Wantai, but they say it´s a technical secret.
Can someone help me with the cable diagram for this board?

[javanree]

Haha "technical secret" ; it's nothing more than a normal cable, all pins connected straight. Just buy a serial extension cable with all 25 pins connected , and if the board side doesn't match (many of these boards have the wrong connector!) get a gender changer too.
Otherwise check eBay, loads of sellers with exactly the same board, some supplied with and some without cable. Some with proper (male) connector, some with improper (female) connector....

[jouguet]

Thanks javenree. I will try. I hope not to fry the Parallel output.
Regards.