[kirkn0909]

Just wondering if anyone has seen this issue.. my Hurco VM1 spindle coolant jet keeps getting activated and in the settings it is being told to stay off. I do not want it coming on at random intervals.

Any ideas on what could be causing this?

[powerr]

have you had your software upgraded or up dated lately? I have seen this happen on Ver7 to Ver8 upgrades, and some software updates.
if your software has not been updated have you had to reload your configuration file on the machine?
There are two parameters for y axis wash down on the larger machines, N95:296, N95:297 if the values are 300 and 7000 make them Zero.
Call your local service tech or Hurco service they can walk you through getting to the parameters on the phone.

[kirkn0909]

have you had your software upgraded or up dated lately? I have seen this happen on Ver7 to Ver8 upgrades, and some software updates.
if your software has not been updated have you had to reload your configuration file on the machine?
There are two parameters for y axis wash down on the larger machines, N95:296, N95:297 if the values are 300 and 7000 make them Zero.
Call your local service tech or Hurco service they can walk you through getting to the parameters on the phone.

Yeah, this problem has been going on for a few weeks now.. right after I upgraded from ver7 to ver8. I will do what I can to take a look at those values.

Thanks for the help!

[powerr]

that would be the issue. it is those parameters. I could be off by one number it is either 295 & 296, or 296 & 297
Call hurco they will walk you through it on the phone. it is not hard.