Hello,
I bought this unit: https://fr.aliexpress.com/item/10050...yAdapt=glo2fra
I attach the manual which is not easy to understand.
I would like to drive it with a rotary encoder (or handwheel but this is the same thing)
Here is my wiring:
pin 2: +24v
pin 3: encoder phase 1
pin 14: encoder phase 1
pin 4: encoder phase 2
pin 5: encoder phase 2
pin 9: +24v
pin 10: 0V
and parameters:
Pn003 = 1 (enable)
Pn096 = 2 (quadrature encoder)
Pn064 = 0
Jog is working fine.
When I set Pn3=1, the shaft hold well, if set to 0 it's free. If i connect pin 6, the shaft also hold, it seems OK
But impossible to have a move when I move my encoder. No error message, just nothing...
Any idea what should I do?
I checked with 2 encoers, and also in step/dir mode with an arduino and nothing...
Help ;(
Thank you