Originally Posted by
Smokey930
Thanks for the response mactec….I have hot wires from the source (220) to R & S and neutral to T, and the ground to the earth ground at the far right...3 hot wires from U, V & W to the spindle going to pin 1,2 & 3......4 is empty and ground to the ground pin.....I'm going to go back through my settings and compare to what you have.....My real fear is that the motor is smoked because after it spins for just a few seconds it sounds like its still trying to spool up but nothing is happening...and on top of that the motor has fail on the plate and appears maybe it didn't pass a inspection of some type but was sold anyway...but i'm hoping its something like a setting.....i'll check..