Hi all

Everything works fine on MK3 Board with latest TNGv2 Software except the Mode3 for X100.
X100 Pin from MPG is wired to EN3A/MD3. Its the Pin 8 on the Breakout Board from Planetcnc

What else i must wire or configure that this works?



Digital Pins on CTRL in TNG Software shows as follows:


If,

X1 then led Input 2
X10 then led Input 3
X100 then led Input 11 But why 11? Should it not be the 13 that lights?

But X100 does not work.

MPG is wired with standard Breakoutboard from Planetcnc IDC Plug to Screw Terminal....just for Info.

MPG is the same as Planetcnc does sell, except that it has no DB Plug.


Best regards
Martin