Hi. A couple years back my computer and mill were working fine with parallel connection.
I fired up computer and got some notice about CMOS issue, presumably battery went dead, I replaced battery.
Now I can't get computer to link to machine (Syil X4)
I tried reinstalling mach3 and driver.
Driver test seems to indicate OK
I can operate spindle manually using controls on mill, but I'm not getting any control from Mach3. I can't move axis's etc.
I'm not sure how to troubleshoot the problem. How do I know for sure if Mach is sending signals to parallel port pins?
Is there any way to test machine? Drivers have single red light for each one, is supposed to be power light.
Is there anything on the 5 axis board to check?
Any help would be greatly appreciated.
Thank you,
Bryan