Hello, I have an Okuma M460V-5AX and it won't boot my system. I make the necessary backup, but it does not want to load, if anyone can help I would be grateful
Hello, I have an Okuma M460V-5AX and it won't boot my system. I make the necessary backup, but it does not want to load, if anyone can help I would be grateful
in my understanding the operating system is booted properly.
What I would do I would start with optical cables - disconnecting one of them makes no difference, means the one connection is faulty
A "P" level alarm is a critical warning that the starting up of the machine will damage it. It is like a car having a faulty oil pump, check oil pressure, if not correct, shut down.
It seems there is a comms fault with a device "mcs" that stops the boot-up sequence
Error manual may indicate what to look for.
I'm guessing here ... "mcs" might mean "master control system"
It could mean a HDD problem, lost parameters, card fault, or cable.
What OS is the machine ? (OSP, P,etc)
what OSP ?
OSP 10
OSP 100
OSP 200
OSP 300
OSP 500
OSP 5000
OSP 700
OSP 7000
higlight please.
MCS= Motion Control System (motor, encoder, drive, etc)
0835 MCS Communication
An error occurred during shake-hand communication with MCS.
[Index]
Axis name or none
[Character-string]
Shake-hand communication error number (2 digits) and [command name]-[channel number]-net address (controller
number)
[Code]
Error data when an error occurred (Zero suppression is effective for upper figures in 8 digits) (Details differ according to the
shake-hand communication error number.)
[Probable Faulty Locations]
1) Faulty software
[Measures to Take]
1) Change the software.
Do you have original DVD with software? with matching options? Go to windows only mode and try to re install it?