[tphillips]

I have a couple on small servo motors with HEDS-5310 encoders. Instead of the standard 5-pin connector, they are outfitted with a 10 conductor flat cable to a 2x5 .100 connector. I couldn't find anything on the web, anyone know the resolution and pinout?

TIA, Terry

[alvarenga]

I do have clients that are in need for those micromotors with 5310 encoders.
The portion of the part number refers to the encoder´s resolution and bore
diameter. Sometimes the resolution of the disk is printed directly on the disk itself. If you have any specs or digital pictures of it.
Please send them to me, so i can check and exchange information.

best regards
Alvarenga, Itamar

[fkaCarel]

From an 1985 HP databook.

The 5 in 5310 is the size 28 mm diameter encoders. The 3 in 5310 points to ordering info, emitter plate only(?), 0 is a complete kit. The 1 is 3 channel (+index), 0 is no index. The 0 is mechanical configuration, 0.6 mtr flatcable. It must be followed by an option letter for resolution:

C - 100 CPR
D - 192 CPR
E - 200 CPR
F - 256 CPR
G - 360 CPR
H - 400 CPR
A - 500 CPR
I - 512 CPR

additional CPR-codes (6000-series)
B - 1000 CPR
J - 1024 CPR

After this comes a double digit, coding for shaft size, which I leave out for sunday laziness.

Pinout bottom view:

Edit: I see that all spaces, that would make the following clear are eaten up, so I will add for each pin (PIN)
Vcc PIN 2 PIN 1 Channel A
NC or Ground PIN 4 PIN 3 Ground
Ground PIN 6 PIN 5 NC or Ground ---With bottom view here the Connector Notch
Channel B PIN 8 PIN 7 Vcc
Channel Index PIN 10 PIN 9 Vcc

Note: all the Vcc's and Grounds must be connected, they function as noise suppression.
Carel

[eladtsa]

hello

i not undestend

if you find dataseet please send me

i need more information
\
tanks

[email protected]

[eladtsa]

hello

i not undestend

if you find dataseet please send me

i need more information
\
tanks

[email protected]

[eladtsa]

hello
if you neet datasheet about heds 5310
send me mail

bay

I have a couple on small servo motors with HEDS-5310 encoders. Instead of the standard 5-pin connector, they are outfitted with a 10 conductor flat cable to a 2x5 .100 connector. I couldn't find anything on the web, anyone know the resolution and pinout?

TIA, Terry

[Gregory Moore]

What type of motors are the encoders attached too? What's the price and lead time for the motors/encoders? Would you send a quote?

Regards,
Greg

TIA, Terry[/QUOTE]

[eladtsa]

What type of motors are the encoders attached too? What's the price and lead time for the motors/encoders? Would you send a quote?

Regards,
Greg

TIA, Terry

[/QUOTE]

i have small motor DC 100W
price of encoder 30 $

good day

[Gregory Moore]

Hello
Please send datasheet on heds 5310 encoder.

Regards,
Greg

[ATGM]

http://www.telusplanet.net/public/mc..._5000_5310.htm

I couldn't find anything on the internet but was lucky and had the 1984 hard copy. Hope this helps you.

Andrew

[tphillips]

Thank you Andrew and Carel for the information. One of these days I need to get back on this project....

Terry