[BillTodd]

Hi,

I have a Control Techniques(?) VC55 (0.55kw 1ph) inverter board running my small SB9 lathe.

Although I have it up and running OK, I'd like to know a little more about the VC55's options (There are several jumps and a additional port)

I believe this board was used in a number of commercial VFD controllers.

Does anyone have any information?

Regards,

Bill

[eng_mike]

Hi,

I have a Control Techniques(?) VC55 (0.55kw 1ph) inverter board running my small SB9 lathe.

Although I have it up and running OK, I'd like to know a little more about the VC55's options (There are several jumps and a additional port)

I believe this board was used in a number of commercial VFD controllers.

Does anyone have any information?

Regards,

Bill

Hi,

It past many years about this question... but

did you arrange manual/ schematic for this inverter?

I need the configuration of the dip-switch.

Thanks!

[Skybug2]

Hello, I'm looking for a manual for the VC55 Drive controller. Can anyone help?
Many Thanks