Please help
I'm the only one in the dept. who even slightly knows how to use the Boxford router A3 HSRi squared, and it's just an ornament at the moment.

I've measured the MDF and clamped it in TICK
I've drawn the image using Techsoft V3 saved it as a .dtd and opened it on the Boxford software, and fill coloured it
I've left line thickness as thin - is this correct?
The mdf is 450 x 280 x 12 and I have a sacrifice board underneath.


When I press 'to mill' it give the following errors:

" The data area passed to a system call is too small. "

I've modified my image to be quite simple to try to address this.


Then
" Access violation at address 40105909in module vc160.bplRead of address 0000004C "

I, just about, know how to change the 'bit' but don't know what tool to change it to?

I have tools


Apologies for my stupidity but I hope you can help