OK, This time I cant figure out how to do this part. The mcx file is attached.
Two sided part. Going to do the part in two vises. One vice does the fist side and the second does the other. First roughed with a 3 flute 1/2 corncob and then finished with a 1/2" finisher. In the first vise the part is milled down to slightly deeper than the main surface. Flipped and held by the edges in the next vise with soft jaws. SEcond surface and bosses are milled and holes are drilled.
Set up G54 and G55 in the WCS. But I cant get it to countour.
HELP!
-Jerry