Im just wondering if im using a 12 groove and a 30 groove timing pulley does it make a difference which one I put on the motor and which one I put on the ballscrew? I would think I would put the smaller one on the motor and the larger one on the ballscrew.But what would happen if I did it the opposite way?
Thanks Mike
Thread: Timing pulleys for retrofit?
Results 1 to 3 of 3
-
11-14-2008, 03:09 AM #1
Member
- Join Date
- Mar 2005
- Posts
- 271
Timing pulleys for retrofit?
-
11-14-2008, 04:04 AM #2
Community Moderator
- Join Date
- Dec 2003
- Posts
- 24260
You will increase the maximum rpm of the ball screw but decrease the torque by the ratio factor, also the inertia ratio will be increased by the square of the increase.
Al.CNC, Mechatronics Integration and Custom Machine Design
“Logic will get you from A to B. Imagination will take you everywhere.”
Albert E.
-
11-15-2008, 12:43 AM #3
Member
- Join Date
- Mar 2005
- Posts
- 271
Im not planning on doing this I just wanted to know what would happen if I did.
Thanks for the reply.
Reply With Quote
Similar Threads
-
GT2/GT3 timing pulleys supplier
By interflexo in forum Mechanical Calculations/Engineering DesignReplies: 15Last Post: 11-29-2015, 11:23 PM -
i want to cut timing pulleys , so help !!
By max_imum2000 in forum MetalWork DiscussionReplies: 18Last Post: 08-08-2008, 06:16 PM -
Timing belts and pulleys?
By Jack Aubrey in forum Linear and Rotary MotionReplies: 11Last Post: 01-12-2008, 11:41 AM -
Timing belt and pulleys
By samakthachai in forum Laser Engraving / Cutting Machine General TopicsReplies: 8Last Post: 10-25-2007, 05:31 AM -
Timing Pulleys
By h_2_o in forum Benchtop MachinesReplies: 7Last Post: 02-03-2005, 05:26 AM
Posting Permissions
