Simple questions for us fanuc control spoil kids. I now have 2 Cincinnati Arrow 750 with acramatic controls. How can I stop the machine from going home after every tool change. I took out every m26 in the program. It even does it with an MDI tool change.
Now one for the more advanced: I need to drill hundreds of .1 holes 1'' deep. I have a .2 deep counter bore. I would like to rapid .19 into the hole(counterbore) then start pecking at about .09 and a retract at .1. (I know retract and clearance and z depth are calculated differently.) When its done come up .1 above the top of the part and go to the next hole. One more thing while I'm on the subject. I just can't seem to get this machine to tap a m3x.5 roll tap about .3 deep. Say with a retract of .1 and a clearance of .15 or any retract and clearance you deem logical. Thanks to all who help. -Mike