587,865 active members*
3,180 visitors online*
Register for free
Login

Thread: Cant Call Up Config - Motor Tuning

Results 1 to 2 of 2
  1. 08-17-2009, 03:55 AM #1
    richlandrick
    richlandrick is offline Registered
    Join Date
    Dec 2007
    Posts
    33

    Cant Call Up Config - Motor Tuning

    I'm running Windows XP Home.

    My earlier installation with Windows 2000 worked fine. I upgraded to Windows XP and now I can't get "Motor Tuning" under the Config tab to come up. All the other options under Config come up properly.

    Any ideas?
    Reply With Quote Reply With Quote
  2. 08-20-2009, 07:31 AM #2
    TOTALLYRC
    TOTALLYRC is offline Gold Member
    Join Date
    Dec 2004
    Posts
    1865
    Verify that NTGraph.ocx is in your Mach3 folder.
    Warning: DIY CNC may cause extreme hair loss due to you pulling your hair out.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Mach3 , Config, Motor Tuning problem ( FILM OF MOTOR)
    By MDF_Markazi in forum Mach Software (ArtSoft software)
    Replies: 7
    Last Post: 04-30-2009, 08:15 AM
  2. Help with motor tuning
    By harrisam in forum DynaCNC
    Replies: 8
    Last Post: 05-09-2008, 02:17 PM
  3. Motor Tuning
    By Smitty911 in forum Gecko Drives
    Replies: 6
    Last Post: 10-16-2007, 10:40 PM
  4. Motor Tuning
    By dwacker in forum DIY CNC Router Table Machines
    Replies: 8
    Last Post: 05-01-2007, 03:50 AM
  5. 120/208 Y-Config. Motor phase conversion
    By gtslabs in forum CNC Machine Related Electronics
    Replies: 1
    Last Post: 06-17-2004, 02:18 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules