Hi Guys,

Found a techno table for sale with stand, but no electrics. Just a raw table.
Travel: X = 33.4" (850mm)
Y = 31.1" (790mm)
Z = 6.8" (175mm)
Gantry Clearance = 7.5"
My requirements, specially Z travel could be met at these dimensions.

The guy will completely outfit it with new techno parts, and warranty it... for an additional $5000.00. This includes a spindle from techno which will get near 30000 rpm.,servo motors, etc.

The table itself is over 5 g's. Is this a deal?
I was told the components and rigidity of the techno machine is outstanding.

This would be my first machine, and be used for doing custom inlays for musical instruments. It would serve me well to not have to spend a lot of time working on the machine assembly, since I have an extensive backlog of hand cut inlays.
Thanks,
Paul