Hello and good evening

I am new here and I’m actually only here for the following reason ...
Unfortunately the help function didn’t really help me!
So - Is it possible to give Tebis the command to process a 3D contour without stopping?

We have the following problem: When finishing component parts, where the contour is relatively deep (45-50mm) and we mill the radius with a SF4R1, then it is often the case that the miller stops and restarts ... that creates cracks into the component part.
Whether the infeed is 0.05 mm or 0.1 mm – it does not matter.
The problem is steady re-access of the contour

Maybe we can work around this problem, if the contour would be delivered from top to bottom in one go ...

Bjorn greetings and thank you!