hi new to cnc i have recently purchased a larken system 400 router has any members any information on them and what software they will work on thanks for your time
hi new to cnc i have recently purchased a larken system 400 router has any members any information on them and what software they will work on thanks for your time
LCAM for DOS and Windows, I believe Larry has them for download off the Larken site?
Al.
CNC, Mechatronics Integration and Custom Machine Design
“Logic will get you from A to B. Imagination will take you everywhere.”
Albert E.
Can i ask, who did you buy it off in the UK ? I think I've only shipped 2 system 400's to the England. Can you post a picture of the inside of the control box?
larry K
Larry are you getting my emails, I have tried to PM you but says your inbox is full
Can you please get back to me
Thanks William
I erased a bunch , but email is the best.
LK
I built those machine with the TC in 2000- 2001 . It ran on Lcam that had toolchanger controls integrated.
The Mach3 must have been put on later, you are on your own with that .
One mistake i made was not putting an oiler in the airline, so the air cylinder tended to sieze up with moisture in the air.
Larry K
Thank you sir! Is the air cylinder you spoke of to release the tool?