I have a 1996 VM16 with Centurion 6 controller running 6.107... I bought the machine as is and new there were problems just not sure what. Once booting it would say Primary HDC falure press F1 to continue. It the loads from sim and I can write a program but cant find it in any directories. I reloaded everything by going into the shell at bootup and reset from the simdisk set new paths and restored everything. It now boots without saying HDC failure but also says floppy drive failure reassigning graphfile path press any key to continue. When I now go to info and paths it list A:\rom B:\ram B:\parts Display is now D:\ and has -1 under it then floppy is now C:. Any help with this would be greatly appreciated. Im thinking about just spending the money to get this upgraded for 2000 dollar but would love to save a little and get this machine making a part again.