Just goes to show that Kurt have done their homework
Yes, they have.
The few occasions I haven't been able to overcome the lift from the jaw while trying to hold tolerance I've found that using a vice that you can put the part below the screw (load path) on the movable jaw will help keep it from lifting. That's not always possible though.
![Quote](images/misc/quote_icon.png)
Originally Posted by
SanDiegoCNC
Since most programmers use the front left corner of the work piece as their datum, the Quad-I's ease of use become apparent.
I LOLed. :rainfro:
Matt
San Diego, Ca
___ o o o_
[l_,[_____],
l---L - □lllllll□-
( )_) ( )_)--)_)
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)