Originally Posted by
mactec54
It's always interesting to see what some people do, and what others buy, thinking that if it works it should be ok
The wiring is not very well done, the most important part, and the heart of all machines
The input Power should be wired R=Hot T= neutral and Ground connected to the Ground Terminal, they can run like this but it is not correct, so this should be your first change
I see also that the spindle Cable Shield is not Grounded, this needs to be Grounded at both ends, Spindle and at the VFD, I'm not sure how you will do this as it looks like everything is mounted on a wood panel, not a good idea for any electrical system
Some of the main Parameters are set, and are correct, but there are more that need to be done to run this spindle correctly and safely, so you don't have these fault problems
Here is the Parameters that you need to set
Huanyang Mactec54
2.2Kw
PD000=0 for Parameter unlock ( 1 ) for Parameter Lock
PD001=0 (1 For Remote Control)
PD002=0 ( 1 For 0-10v Terminal Control or Remote Trim Pot Control ) ( J1 Also Needs to be set for Terminal Control )
PD003=400
PD004=400
PD005=400
PD007=20
PD008=220 (Motor Rated Voltage )
PD009=15
PD010=8
PD011=120 ( 100 Minimum Setting with Quality VFD, 120 is Safe)
PD13= 08 is for Factory reset, Only use this to set VFD to Factory Default Settings
PD014 Acceleration=12 ( Adjust to suit)
PD015 Deceleration=12 (Adjust to suit)
( PD15 is ignored IF PD26=1 Then the Spindle will Coast to a Stop)
PD041=8 ( Carrier Frequency )
PD141=220 ( Motor Rated Voltage )
PD142= 9 ( Motor Amp Rating 2.2Kw Spindle 10 amp max )
PD143=2 ( Motor Number of Poles)
PD144=3000 (Max Motor RPM) =3,000= (24,000)
PD70=0 ( This may need to be set to 1 if Control Voltage is 0-5v )
PD72=400
PD73=120 ( 100 Minimum Setting )