I'm trying to get back to my Machine after an extended period and having hell getting to to accept the code for a simple 2d plate that it only has to make 4 slots and one hole...
Using BobCad V31 and the BC_3x_ Mill post I am getting a "Parser #4 internal addressing error " that , from what I understand, has to do with calling canned cycles..
Looking at the enclosed code I see where there are some G codes not supported by the DX32 controller... But I have no idea if they are the cause of the error. I have tried shorting the code to just about the first 10 likes and it also results in the error... I have taken out the G54 duplication and even took it all together with no change..
Just what is needed in that first line?
Thanks for any help and hopefully I can get this going before I am completely bald!