I just bought a Shoptask Tri-power. It has a oil leak. The spindle bearings are dry and make noise. Thr mill manual feed is totally out of adjustment. The gears have so much backlash that it skips a tooth. Also percision bearings are practiclly non existent. It will take 5 to 6 months lead time to get the bearings. Shoptask could not tell me where to get the bearings either. They don't have a clue and they are so out of touch I won't even call. This machine will need all the bolts replaced with grade 8 bolts. This thing was just slapped together. They could have done a better job with quality. The headstock was full of casting sand. The gears in the headstock were binding so I had to tear into it and found burrs on all the bushings causing the gearbox to bind. I will have to tear the whole machine apart and start over. The second and third shafts in the main shaft gear box are not even on bearings. They are very sloppy steel bushings with burrs all over them.I will need to redesign them later and add nedle bearings with hardened shafts. This thing is cheap cheap, cheap. No wonder their is so much run out everywhere.