Hi! What is a reasonable value of velocity and acceleration on the x,y, and z axes of a Taig mill? I have 280 oz-in stepper motors on each axis. Right now I am using the EMC2 software. I currently set the max velocity to be 30 ipm and max acceleration is 2 inch/sec^2. I was cutting a small lithophane (3 inches wide by 2.25 inches tall) with 30ipm on x,y, and z and I have a strange offset. Is this caused by missed steps or maybe my old computer (1GHZ Pentium 3) had a hiccup? I'm thinking the z-axis velocity and acceleration are probably too high. Thanks!