[CAN MACHINE]

We have a 2001 VF1 which developed a major coolant leak in the main line for the flood coolant. I shut the machine down and removed the sheet metal that covers the head. I powered the machine up again and turned on the coolant to see where the leak was then powered everything down again. I found the leak was at the very top where the line bends to come down into the head. I took the entire line out and replaced it. I then put all the sheet metal back on. I turned the power back on to the machine and now it wont boot up.

Normally when I hit the main power button on the front I get a loud "BEEP" then the machine boots up. This does not happen the screen is blank. I can see a little green light in the control and it is on, so there must be power getting to the control?

Any suggestions?

[DaOne]

Check to voltage going to the board stack (CPU, Video, MOCON) You should have +12 and +5 volts. Also try holding down the "PRGRM CONVRS" button on the keypad at boot. It should show you your CPU version and memory. Dont press any more buttons at that point turn it back off. Let us know what you find.

[Wizzard of H]

Check the 115 volt solenoid, pump, and fan wiring in the spindle head.
A short in one of those might trip a breaker that supplies power to electronics.

[CAN MACHINE]

I checked all the fuses and breakers this morning and they are all good. Tried holding down the "PRGRM CONVRS" button on the keypad and that didn't work either. I called the closest HFO and they were unhelpful as usual. They don't really want to help over the phone because they can log 6 hrs of travel time at $115/hr. to come fix it. My boss can't wait any longer so they are coming tomorrow. Last time there was a sticky limit switch on the tool changer and he knew exactly what the problem was and it took him five minutes to fix. Thanks for the help. I'll post back what the problem was.

[Wizzard of H]

Still...
There are things you can easily check.
If you were working in the spindle head area, almost certainly something there caused it.
1) Does the main contactor engage when press ON? If not check main power.
2) Do any red LEDs on the processor electronics (under cover top left) show on? If not, low voltage power supply is off - 3x6 card top right.
3) If 115 VAC to low voltage power supply is missing, check breaker 3 inches below it.
4) If LEDs on processor are on, something in spindle head could have shorted 5 volt power. That could be an encoder cable.
5) Look all over for loose, pinched, or crushed cables.

[Machineit]

This is probably not it, but worth checking. Where I worked a couple of years ago, we kept have squirrels go up on the power lines and bar-b-q themselves and that took a leg of our three phase out. One day it only a certain leg out and left two on and the Haas Mini-mill had power but would not fire up. We didn't notice what it was untill we found some office lights out.

Probably not it but check your breakers and make sure you have all three legs at the machine.

Mike