[haitd]

hello everyone. I have a lathe MORISEIKI SL-2 FANUC 3T. Led ER3 in Panel always light and turret not change. Please help me.
Regards

[underthetire]

ER3 is machine alarm. Check your hydraulic pressure, turret limit switches, spindle motor fan etc.

[haitd]

ER3 is machine alarm. Check your hydraulic pressure, turret limit switches, spindle motor fan etc.

I checked, hydraulic pressure, turret limit switches, spindle motor fan, thats all normal.
X, Z axits and spindle ok.
If you have manual Fanuc 3t, please help me. Thanks.

[alexfanuc]

Probably the turret is out of position?

[haitd]

Probably the turret is out of position?

Right.
I made ​​the turret back to original position, and I think reference position wrong. But I don't know set up reference position.
Sorry for my english is bad.

[alexfanuc]

How did you move the turret?
If you put in JOG mode and then try to move the turret, will it move?
Sometimes when you try to move the turret to any other position in JOG mode then the turret should index automatically.
Regards

[Sergiogc]

If the turret lost its position, you'll need to see how it is being controlled, Probably it is contrlled using a driver, that means that you need to tell to the driver its firts position or home or tool # 1, it is going to be hard because normally I solved many of these problems but using the ladder or schematics...I hope this helps