Hi,
As a newbie, I'll probably ask for something very common: help to decide which mill should I buy (at least for now). I am also thinking about a cnc approach.
But this time I will try to do it from a bottom up approach. I need to make very small parts from metal (brass, 6061 maybe stainless steel). As you can see in the attached picture, is a little complex. It's quite small (about 20 mm) with 2 mm holes.
So, the question is: should I buy a small mill like a Proxxon MF70 or maybe a bigger like Sherline, X2 or a Proxxon FF400. Any advice here?
Sorry for my bad english
Best regards from Brazil,
Luis Carlos Silva