Re: mill wont retract after drilling hole...
it may be the rpm ... the 1st time you post your problem i realized that is not the code, but something else
now, it just ring a bell
if rpm is low, than :
... if effort is high, motors can not reach the "sweet" zone, thus tool stops, or
... if effort is low during feed, effort may increase near end point because of next move, on Z+, maybe correlated with a LM, but i am not sure of this, since mill reaction time is >1sec, or
... next block is not executed, because current comand is executed without confirmation - i hit in this case a few days ago : thus, the spindle rotates at desired rpm, but cnc does not compute next code line
however, if you wish, share some cutting specs for this tool; if it runs after another, please share data also for previous tool / kindly !
Ladyhawke - My Delirium, https://www.youtube.com/watch?v=X_bFO1SNRZg