[Foreigner1976]

Hi!
I have such problem. In the morning, I turned on the machine, run all axes to the machine zeros and received the error 2 EMERGENCY STOP. I turned off the machine with the rear switch and turned it on again, but the green button on the control panel did not light up. Found that the 24V 120W power supply unit is not working. Disassembled and repaired the 24V power supply, the green power button on the control panel is now light, but the following alarms remain active:
2 EMERGENCY STOP
3 EMERGENCY STOP
382 SPINDLE POWER CUT MALF.
383 PLC EMERGENCY STOP RELAY FAULT
385 ESTOP SAFETY RELAY FAULT

Please help.

[Foreigner1976]

Anybody knows anything about this problem? All LEDs are lit or blink green on all units. No red LED

[Foreigner1976]

Problem is solved.

[ANDRZEJAKSA]

Problem is solved.

Help!!!!

[machinehop5]

...what was the problem ?

[ANDRZEJAKSA]

...what was the problem ?

Jak rozwi?za? tenproblem?

[ANDRZEJAKSA]

...what was the problem ?

Jak by? problem....

[ANDRZEJAKSA]

Hi!
I have such problem. In the morning, I turned on the machine, run all axes to the machine zeros and received the error 2 EMERGENCY STOP. I turned off the machine with the rear switch and turned it on again, but the green button on the control panel did not light up. Found that the 24V 120W power supply unit is not working. Disassembled and repaired the 24V power supply, the green power button on the control panel is now light, but the following alarms remain active:
2 EMERGENCY STOP
3 EMERGENCY STOP
382 SPINDLE POWER CUT MALF.
383 PLC EMERGENCY STOP RELAY FAULT
385 ESTOP SAFETY RELAY FAULT

Please help.

Help...

[Foreigner1976]

I apologize for the late reply. The reply notification does not work.
In my case it was a software problem. I performed the memory reset procedure, reinitializing memory and all the errors disappeared, the machine works normally.
If you do not know how to do this, then I will try to explain this procedure.

[Vegas1989]

Hello. I encountered the same problem.
I checked the entire electrical circuit, everything works.
I can't reset the errors.
Please tell me how to reset the memory correctly?
Maybe there is some literature that fully describes this procedure?

[Foreigner1976]

This document describes the memory reinitialization procedure.

[Vegas1989]

Thanks, friend!
The work is at a standstill, and the equipment is needed.
I will try, and I will write about the results.