I have a Fanuc Oi-MC cnc system, as I would like to change it's parameters, I had tried to enable PWE parameter write enable in MDI mode but it could not get change. Kindly help me to solve this problem.
I have a Fanuc Oi-MC cnc system, as I would like to change it's parameters, I had tried to enable PWE parameter write enable in MDI mode but it could not get change. Kindly help me to solve this problem.
PWE has to be enabled from the "Settings" page, not the "Service" page, and in MDI, then parameters are changed in the "Service / Parameters" page
OK, silly question time.
Is the memory protect key off?
Bob
You can always spot the pioneers -- They're the ones with the arrows in their backs.
Please ask your MTB, they must have written some interlock in ladder (it must be a PB or the edit key).