Hi!
Issue 1: I can't figure out a way to control the starting position of a pocket feature.
I defined a point on the edge of the stock geometry where I would like the ramp (or even a plunge) to start so that it enters the usable part of the material at the right height, but it ignores me and starts on the right side instead of the left
Issue 2: The software is not holding the tool dimensions which means not only the parameters get passed incorrectly to Predator (that is why the tools are skinny in the video), but also it misses tool changes because it can't figure out that tools are different (that is why it is drilling twice the same hole in the video instead of doing a tool change and chamfering it).
What am I doing wrong?
Video: http://www.screencast.com/users/Extr...a-32566aae005f
Thanks!