[nzrain]

Hello, this is my first post. I have a problem with my FANUC 15M controller, I lost all my controller parameters and now I need to re enter them. I have a hard copy by am not sure how to enter them into the controller. a IPL screen comes up with a couple of options but I am unsure where to go from there.

Cheers, Ian.

[memoryman]

Do you have the parameters in a file, so you can use a computer?
I can fax/email you the procedure if you do. If not, it will take longer but I can still help.
Bill Peiman, President
Tulip Electronics Inc.
2065 Conservation Road
Campbellville,On L0P 1B0
Canada
P (905)854-6668
F (905)854-6669

[nzrain]

Hello Bill and thanks for your reply. I don't have it in a file, its currently on a roll printout, but will type it into some type of format, I think .txt file might do? If you have any thoughts about that, I'd love to hear them. Also if you could email the info on how to transfer them to them machine, that would be great. Cheers, Ian.

[memoryman]

If you re-enter the parameters by hand, you must input the passwords:
23678625- enter
37264699 -enter
19261161 -enter
enter the number of axes (param 9000)
now enter your options in hexadecimal.
then exit IPL and enter you parameters followed by PC parameters.
It may be worth your while to phone me at some point (I live here)
Bill

[nzrain]

Thanks Bill, I might try and ring you sometime, I live in New Zealand so I'll have to work out the time difference. Another question though, how do I actually enter the passwords and parameters. From the IPL menu, do I have to select on of the options, is it SET FILE, or FILE, or SETTINGS, do I just enter them directly at the curser prompt? Sorry to sound dump! I am very greatful for your help. Cheers, Ian.

[memoryman]

I understand New Zealand (have customers there). Turn the control on pressing 7 and 9. when you are in the ipl screen enter 99 , press INPUT,enter the first 8 digit group and press INPUT, next group and press INPUT, last group
and press INPUT. The screen should now show:
SYSTEM GENERATE
CHECK SYSTEM LABEL :PASS
AXIS ?
now enter # of axes (param 9000) and press INPUT; you will see:
OPTION 01 ? this is param 9100 : enter in hexadecimal and press INPUT
OPTION 02 ? this is param 9101 : enter in hexadecimal and press INPUT
etc. If you make a mistake, you must start all over.
Bill

[9xpro02]

Do you have the parameters in a file, so you can use a computer?
I can fax/email you the procedure if you do. If not, it will take longer but I can still help.
Bill Peiman, President
Tulip Electronics Inc.
2065 Conservation Road
Campbellville,On L0P 1B0
Canada
P (905)854-6668
F (905)854-6669

Dear Sir.
I got same problem.
Please sent the procedure help me via my address email: [email protected].


I am very grateful with your help.

Best Regards.

[9xpro02]

Dear Sir.
I have same problem.
So please sent to me the procedure.

I am very grateful with your help.

Thanks and Best Regards.

[9xpro02]

This is my email address: [email protected]

Thank you so much for your help.

[jorber]

Good
Thanks

[rvlaxz11]

Buenas tardes alguien tiene la lista de parámetros fanuc 15m q.me.pueda proporcionar