I recently disassemebeled my machine to move it. i disxconnected the axis by removing the splices between the controller and the mill. However now that i have reconnected everyhting, my x axis will only travel in one direction. i've had this happen before, but i can'tr remember what the problem was. could it be software related, i'm using mach3. I'm using the gc11 board from cnc 4pc.
I does show it sending a signal according to the lights on the bob. could i have a broken wire or connection.
i think i remember there being a setting in the software that would change this, but i'm not sure what the problem was the last time.
Please help , all suggestions considered.
Mark