Hello,

I am servicing this TL-10, it has a cold fire 2 simulator or processor (not really sure what that is) Anyway there is a link in the Haas website to boot the system when needed and I needed to do it but when I do the BBU clear command I get an error that says that this area is not actually blank. I think it might be a bad board. Has someone faced this? Any hints?



"Do these steps to clear the BBU (battery back-up) memory:

Type M6000000 6FFFFFF and push [WRITE/ENTER] [3].
After MEMORY TEST PASSED, PRESS RESET TO STOP appears (3) times, push RESET [4]."

Attachment 514538