We have 4 OKK HM1250 Machine centers. Two of them have issues where when rough milling the "B" axis will actually lose positon...the mill will actually push the axis around. Has anyone else had this?? Anyone know ofa fix other than lighter depths of cut...or lower feedrates??
Thread: "B" Axis Break Issue
Results 1 to 2 of 2
Threaded View
-
04-12-2012, 02:06 PM #1
Registered
- Join Date
- Aug 2008
- Posts
- 2
"B" Axis Break Issue
Reply With QuoteSimilar Threads
-
Common Laser Problems and Solutions(1) - Y Axis movement issue on "Test"
By Gweikelasers in forum Laser Engraving / Cutting Machine General TopicsReplies: 3Last Post: 12-22-2016, 10:45 PM -
Feed Rate Issue- K2 says: "200 in/min max" Mach3 says: "Running at 800"
By jmsiefer in forum K2CNCReplies: 3Last Post: 06-25-2014, 03:51 PM -
4th axis "C" rotary table on a mill and "C" axis on a lathe
By Ya-Nvr-No in forum MadCAMReplies: 17Last Post: 02-22-2014, 06:58 PM -
X Axis "Goes Off Pattern", "Awry", "Skewed", "Travels"
By DaDaDaddio in forum Laser Engraving / Cutting Machine General TopicsReplies: 1Last Post: 05-06-2013, 09:59 AM -
took 4 year "break" now trying to get g320 working again
By Smertrios in forum Gecko DrivesReplies: 4Last Post: 12-17-2011, 04:27 PM
Posting Permissions
