It just occurred to me, that now we have built a cnc machine, we also have an over head router/shaper by default !

I wanted to put some profile on some shelves I am making, and have been putting it off, as my router is mounted in the cnc machine.
Lying in bed this morning, after I just woke up, I realized, that I could put the profile bit with guide bearing in the router whilst it's still mounted in the machine, and still run the boards through manually, like I would on a router table.
I don't know why I didn't think of that before !

I can't wait to give it a try now.

Any one else doing this ? or have any other uses for the CNC that might not be obvious ?