Hi.
So another basic question regarding cnc.



So i would like to cut a 90º inside corner (left image) to cut out a square out of the material (10mm thick plastic). Of course since i am using a 1/8 drill i will get something like the center image.

However i need to fit a square (with sharp edges) inside the hole i am cutting.
The solution that seems obvious to me would be to do it like the image in the right.
I could design that into the vector file, but it seems something common enough to have an automated solution, however i cannot find it in artcam.

The only thing i could find was the inlay option, but that would only work if i could also round out the corners in the piece to be inserted, but since it's cut on it's side that would be very difficult.

Regards