[Arbo]

I bought some cutting boards from Wal-mart that are 5/16" thick with the intent to carve the 3D Haab calendar into if I can invert the tool paths and cut it from the rear. It has a slightly textured surface on both sides and I want a smooth outer surface. Haven't had time to do anything with it so far.

Think it will work ok when backlit?

I don't know, if you vcarve it, inverse, it might look strange, since you'll get 'darker' fading to lighter near what would be the surface. It may just need straight cuts rather than 'v'... I should make a relief of it and try it as I can invert and fiddle with it to see what it might look like.

What's up with these spammers around here?