Hi,

I used my machine for a few hours yesterday and then shut it down. Went out today to do some more work. Fired it up and the red indicator for the computer does not light. When
I try to move the Z axis upward + it does not move. The readout shows it moving but there is no apparent motion, no motor sound, nothing. The spindle is setting down on a piece of two by four on the vice so I have not tried to move either X or Y.

I am not an electrician so I am not sure what to do next. Has anyone out there ever had this problem? Can someone tell me what to check and in what sequence?

Thanks,

Ernie