I have the SSR and breakout board pictured. Currently I have it wired as follows.
pin 3+ of SSR to 5v+ on breakout (Verified 5 volts with DVM)
Pin 4- of SSR to to output 1 of Breakout.
Pins 1 and 2 of the SSR I have yet to figure out how they wire to the torch.
When I run Mach 3 on a test bracket I made in Sheetcam, the SSR doesnt do anything. The red light just stays lit all the time. I used Diagnostics in Mach 3 to manually turn on/off spindle controll and no changes. All i get is Mach says output one is active and output one blinks on the screen when I turn it on. I plan to hook this up to a Thermal Dynamics cutmaster 52.
I'm wondering if anyone knows how to wire this up, because I don't think I did it correctly.
Results 1 to 12 of 12
Threaded View
-
12-19-2012, 11:05 AM #1
Registered
- Join Date
- Aug 2011
- Posts
- 53
BOB to Solid State Relay Plasma CNC wiring
Reply With QuoteSimilar Threads
-
24Vdc Solid State Relay not the same as mechanical relay??
By cjchands in forum CNC Machine Related ElectronicsReplies: 7Last Post: 11-10-2010, 07:40 AM -
Using a solid state relay as a main stop relay
By garagefela in forum CNC Machine Related ElectronicsReplies: 4Last Post: 02-26-2010, 11:27 PM -
Router 0/1 with solid state relay
By bigz1 in forum CNC Machine Related ElectronicsReplies: 6Last Post: 04-25-2008, 02:37 AM -
solid state relay question
By aegfurn in forum CNC Machine Related ElectronicsReplies: 9Last Post: 02-24-2007, 04:09 AM -
Solid state relay
By N4NV in forum CNC Machine Related ElectronicsReplies: 13Last Post: 05-07-2006, 06:19 AM
Posting Permissions
