I have an RF45 that has developed a problem where in high gear (H3) it is slow (~2sec) to spin up to full rpm. This has only just started happening. It used to spin up to full speed almost immediately. It has been proposed that it might be the starter capacitor. Has anyone else had this issue?
Results 1 to 3 of 3
Threaded View
-
01-07-2013, 04:17 AM #1
Registered
- Join Date
- Aug 2012
- Posts
- 25
RF45 issue: spindle slow to reach max rpm
Reply With QuoteSimilar Threads
-
Spindle Won't Reach Speed after Brake On while Spindle Start
By mflux_gamblej in forum Bridgeport / Hardinge MillsReplies: 44Last Post: 06-11-2014, 04:59 AM -
No/Slow Spindle
By JBA Precision in forum Benchtop MachinesReplies: 0Last Post: 09-20-2012, 05:02 PM -
No response from motor at slow speeds. Heat issue?
By CarlofET in forum DIY CNC Router Table MachinesReplies: 5Last Post: 05-07-2010, 08:46 PM -
Slow Spindle Speed
By mikemill in forum Syil ProductsReplies: 8Last Post: 01-20-2010, 01:48 PM -
Rong-Fu 45 / RF45 Clone Mill Spindle Stop
By fignoggle in forum News AnnouncementsReplies: 1Last Post: 11-06-2009, 06:05 PM
Posting Permissions
