[Marty_Escarcega]

Some progress to report on this project. I had my electrician out today to hook up the transformer. It was a bear to figure out how to wire it up since it has so many taps and the wiring diagram was a bit of a head scratcher, even with three of us looking at it, but we finally figured it out. And hey what do you know I got 380V power in the shop now.

So I powered on the machine side disconnect and turned the machine on/off switch and the control came right up. Which is a result... sort of. The control powers up when I hit NC On but not much happens when I hit AUX On. Hrm....

Well tomorrow I will get to the back side of it and see what I can make of it.

If anyone has advice or suggestions I am all ears.

Well, progess is progress. :-). So did the control completely come on? Any errors on the display? I wonder if the hydraulic system gives any feedback to the control? I take it Emco USA wasn't of much help with documentation? Keep us posted of your progress. Maybe a picture of the video display might help. Someone may know the control.

Marty