i have a few questions for the guys running these drivers.
i purchased(traded) for a 3 axis and 4 axis board. the dip switches i was told were set to properly run my motors(1-4 on, 5-6 off) and i was told not to mess with them. i am running a spectralight/sherline machine with the original round motors(see pic). i plan on running 24v 15a psu. but i believe the driver i got with the machines was only 12v(burned up driver when recieved) is this going to damage these motors? i was told no but i am just checking my source. i had to replace two can type capacitors on the 3 axis, one was leaking and another was installed backwards and bulged. i have not done any modifications apart from adding on leads to the input plug. what should i do to get this running correctly and reliably? i am currently getting ready to run with the 3 axis board.
pics of both boards when i received them and a pic of one of my mills is attached.
thanks.


Kevin.
Nsr customs.