Hi,

Hopefully someone else has got some experience with these things. Again no instructions supplied with the "kit" i got, or with the smooth stepper..

Its plugged in, im getting two short Flashes, and a pause, the two short flashes, as if its in "wake-up" mode. The documentaiton says its going to be running with an IP address of 10.9.9.9 I've set up my network so i can reach that, but when i ping it. ( ping 10.9.9.9 ) i don't get any response.

Will it in fact repsond to a ping?

I have a C25 board to plug it in, from cnc4pc.com i'm hoping i've got the ports set up right.. Again theres a real lack of documentation. I was sent a diagram for a differnet controller, to the the one that i got.

ANy clues appreicated.