This is the router I have Welcome to the Vortech Routers 4X8 Router Page

It has a 6hp spindle motor

I am needing to cut 18mm finished birch plywood. I normally cut with cheap bits with 4 passes. Now it looks like I am going to need to make things a lot faster and cleaner.


Could I cut threw it in 1 pass with. Onsrud Max Life Compression Spiral (3/8 Cut, 1–1/8 Single Flute) 15,000 RPM at 150ipm?


Or am I completely off?

I have not actually bought any bits. I'm just trying to figure out what my best setup would be.

From reading around everyone seams very nice and helpful here. So I figure this is a great place to ask.

Thanks in advance for the help. I'll be looking forward to a response.

Justin