I,m wanting to convert my el cheapo drill press to a manual mill. This is the table I just purchased http://www.grizzly.com/products/G8750
http://www.grizzly.com/products/G8750 and I,m attaching it to this drill press
http://www.toolprice.com/product/9102L
http://www.toolprice.com/product/9102L
I read somewhere that someone said the problem with using a drill press is that as you lower the spindle the shaft looses its rigidness. So my idea is to put something under the table that I can raise and lower the table without having to lower the spindle. So my question is,"is there any device out there that can do this ?" And " Is it a good idea?" Any comments are welcomed.