I'm in the middle of a build, and purchased an Antek PS-4N48R5 Toroidal power supply for my Ethernet smooth stepper (5v) and Stepper Motors (48v). I put the power supply in the enclosure last night and hooked up AC power to it. There are 2 120v connections for the TPS. I'm running 120v to it, so I only hooked up one. When I put my multimeter on the DC outputs, with no load on the supply, I couldn't really get a reading on the voltage. That was on both the 5v and 48v voltage regulator module. I was getting 36v on the AC input side of the (48v) voltage regulator though, and 12v on the 5v voltage regulator. Both of those had a steady output of power. Is this normal? I was afraid to plug my electronics into it without actually seeing what the output voltage was.